france Limberoller : idler for belt conveyor spain Limberoller italia Denmark nederland Limberroler Maroc russia  
rouleaux guirlande
rouleaux guirlande email

Assembly - Maintenance - Lubrication

  1. Supports
  2. Layout of supports
  3. Spacing between rollers
  4. Auges
  5. Other rules to observe
  6. Lower rolls
  7. Points of fall

Limberoller references


cables qui cassent

Your cables break click here


PDF Documentations

documentation Limberoller


Limberoller PUD

documentation Limberoller PUD


Assembly - Maintenance - Lubrication


6°/ Lower rolls

On the return side it is recommended to use LIMBEROLLER® system rollers mainly when the transported products are sticky. Indeed, the LIMBEROLLER® is an anti-clogging roller that keeps the band properly aligned. In general, the trough accommodated in the return roll is relatively small (10 °). However, if the operating conditions require it to obtain either a better cleaning of the strip or a more effective guidance, a larger trough may be used.

Whatever the trough used for the rollers, it must be ensured that the belt bears correctly over its entire width, this is very important, the duration of these rolls depends on it. A belt that carries only on its edges would lead to rapid wear of the lateral wafers and the lowering of the lower LIMBEROLLER® as in the case of the upper rollers.




The Limberoller 7 important features =>

rouleaux polyurethane rouleaux caoutchouc

resistant anticolmatant nombre de rouleaux reduit centrage aux alimentations centrage des brins de retour chargement en auge profonde rapidité de montage et de demontage